...and I was all like, SCREW YOU PAL!!! [something about gundam models]

[Artimus Gigan]

HAHAHA...a mere pun

Anyways about Master Grade Gundams, apparently they have screws that need screwwing, only thing is, I'm not sure what make of screwdriver works. I tried an Eyeglass philips screwdriver and that worked only half way and the other half of screwing it in I had to use plyers to grip the screw as I turned the piece.

Are there some special screwdrivers that are supposed to do it, because there has to be an easier way considering that the eyeglass screwdriver broke while I was turning the screw....

[Ben]

My brain hurts.

[MahouShoujo13]

HAHAHA...a mere pun

Anyways about Master Grade Gundams, apparently they have screws that need screwwing, only thing is, I'm not sure what make of screwdriver works. I tried an Eyeglass philips screwdriver and that worked only half way and the other half of screwing it in I had to use plyers to grip the screw as I turned the piece.

Are there some special screwdrivers that are supposed to do it, because there has to be an easier way considering that the eyeglass screwdriver broke while I was turning the screw....
Oh boy.

Are the special screwdrivers inside the kit?

[Keiichi]

Just use a regular philips head screw driver big enough to fit and screw the buggers in. The screws make for stronger joints that won't wear out as fast as snap togeather parts. Which one are you putting togeather anyway?

[Artimus Gigan]

Just use a regular philips head screw driver big enough to fit and screw the buggers in. The screws make for stronger joints that won't wear out as fast as snap togeather parts. Which one are you putting togeather anyway?Kaempfer and Heavy Arms Custom

I tried about 7 regular philips heads which didn't work because the head was too big before the eyeglass screwdriver which was smaller and actualy fit somewhat.

[Lord Dalek]

My brain hurts.My brain hurts too.

[Conekiller]

HAHAHA...a mere pun

Anyways about Master Grade Gundams, apparently they have screws that need screwwing, only thing is, I'm not sure what make of screwdriver works. I tried an Eyeglass philips screwdriver and that worked only half way and the other half of screwing it in I had to use plyers to grip the screw as I turned the piece.

Are there some special screwdrivers that are supposed to do it, because there has to be an easier way considering that the eyeglass screwdriver broke while I was turning the screw....
I ran into a similar problem while building my GodGundam Master kit. at first I used a really small screwdriver (my dad has a set of smaller ones) Which only seemed to work a little, and hurt my hands. Then I used a regular, albeit slightly smaller tipped, phillips and it worked fine. I had a good grip on the handle, and I didn't fudge around with the limb as much.

I don't remember Heavy Arms custom needing screws......

(that should show Twage and Dalek how to actually contribute to a legitimate post:sad: )

[Ben]

(that should show Twage and Dalek how to actually contribute to a legitimate post:sad: )

Hey, you would never have known this thread was about Gundam models if I hadn't edited the thread title. So there.

[Conekiller]

Hey, you would never have known this thread was about Gundam models if I hadn't edited the thread title. So there.very well then. Dalek has no excuse.:D